The main reasons for Golf Cart line failure
2025,02,25
Lithium Golf Carts are a good helper to ensure our fire safety, but Lithium Golf Carts also have problems. When the controller of an
Golf Cart has a line failure, do you know what the reason is? The editor summarizes the failure as four reasons:
1. The internal power supply of the controller is damaged; the probability of damage to the internal power supply of the controller is generally as follows: short circuit of the internal circuit of the controller; short circuit of the external control component; short circuit of the external wire.
2. Damage to power equipment. Golf Cart motors may damage power equipment. Poor quality of power equipment or insufficient selection level. Loose installation or vibration of Golf Cart equipment. Overload of Golf Cart motors. Damage to the drive circuit or unreasonable design of power equipment parameters.
3. Due to damage to the connecting wire and damage or detachment of the connector. There are many possibilities for control signal loss caused by damage to the connecting wire and poor contact or detachment of the contact plug-in: unreasonable wire selection; incomplete wire protection; and improper curling of the connector.
4. The controller works intermittently. The controller works intermittently. Generally speaking, there are the following probabilities: the equipment itself drifts in a high or low temperature environment; the overall design of the Golf Cart controller causes the local temperature of some equipment to be too high, causing the equipment itself to be in a protective state; poor contact.
In addition to the above, you should also pay attention to the installation. Be careful to connect the controller and be careful not to be careless when installing the wiring. Try not to connect the switch line directly. Use insulation tape to "wrap" it, because if there is water in the switch connector, it will cause the car to fail or the car will be out of control.